Oct 04, The bushing bore must be clean and free of any snags of metal that may have been raised during the bushing removal process. Powder-coat or paint may also be in the bushing bore and should be removed to ease bushing installation. The urethane rubber bushing from the Corvette Central sway bar end link kit is easily pushed in by hand into the Estimated Reading Time: 12 mins.
May 15, I have also shown how to remove the rear suspension bushings for urethane bushing replacement. Early on we discussed the availability of rubber bushed suspension components. Corvette Central does have the spindle rods available with rubber bushings ( Set of 4) or with polyurethane bushings ( Upper, Lower). Camber strut rods Estimated Reading Time: 13 mins. Nov 01, There are a few ways to remove the rubber bushings: burn them out, force a drill bit into the rubber until it comes loose or do them in this manner.
I begin by cutting the outer portion of the upper control arm bushing that protrudes past the arms bushing shrubdisposal.buzzted Reading Time: 11 mins. shrubdisposal.buzzchase parts online: shrubdisposal.buzz Corvette Suspension Rebuild - The C4 Suspension Adventure Here are the basics. This rear suspension is the same as what was used in Some things have been refined but the basics are all the same.
You need to be concerned about bushing wear and deterioration. These bushings hold up nicely but remember once you get overmiles andFile Size: 1MB.